IOTA100 Preparative Pump

100ml/min 15MPa

OEM built-in pump with flow rate up to 100ml/min.

Availability

Related variants

Manufacturer
Ecom
Part number
PYE0000X

Iota 100 has flow-rate range 1 – 100 ml/min. Maximum operating pressure is 15 MPa (2176 PSI).

It has two pistons connected in parallel, with diameter of 3/8”. It is suited for preparative and flash applications in liquid chromatography but also for solvent pressurizing by samples extractions, etc. Beneficiary is also a very stable run even at low flow rates.

This Pump is designed as OEM / built-in unit.

There is a possibility to use this pump even at high pressure gradient mode, where are two, three or four units controlled from PC using RS232.

Control board is mounted at the unit back side therefore the installation is very easy. Only connect power voltage and RS232 and pump is ready to work.

When working with buffered solvents, it is possible to use pistons back washing.

Pump is supported with software ECOMAC and Clarity.

IOTA PUMPS are equipped with pressure sensor.

Flow rate 1 – 100 ml/min
Maximum operating pressure 15 MPa (2176 PSI)
Flow rate setting 1 ml/min steps
Repeatability of flow rate adjusting ± 1 %
Accuracy of flow rate setting ± 2 %
Wetted materials stainless steel, PEEK, ceramic, seals
Communication RS232
Control RS232
Power supply 24 – 36 V DC
Power input 100 W
Dimensions W x H x D 212 x 153 x 338 mm
Weight 7 kg
Output capillary outer diameter 1/16”
Input tubing outer diameter 1/8”
Upper pressure limit (MPa) 0.1 – 15 (2176PSI)
Filename Type
Info-Iota50_100_300_pump-en.pdf pdf (172,17 KB)