THETA50 Preparative Pump

50ml/min 30MPa
OEM built-in pump with flow rate up to 50 ml/min.
Availability

Related variants

Categories
Manufacturer
ECOM spol. s r.o.
Part number
PT00000X
Theta 50 is a pump with two pump pistons connected in parallel, with flow rate range from 0.1 to 50.0 ml/min and maximum operating pressure 30 MPa (4351 PSI).
 
Pump is suited for preparative and flash applications in liquid chromatography but also for solvent pressurizing by sample extractions, etc. Beneficiary is also a very stable run even at low flow rates. Also available in configurations made of certified bio-inert materials.
 
This pump is designed as an OEM / built-in unit.
 
There is a possibility to use this pumps even at high pressure gradient mode, where two, three or four units are controlled from PC using RS232 or voltage.
 
Control board is mounted at the unit back side, therefore the installation is very easy. Only connect power voltage and RS232 and pump is ready to work.
 
When working with buffered solvents, it is possible to use pistons back washing.
 
Pump is supported with software ECOMAC and Clarity.
 
THETA pumps aren't equipped with pressure sensor.
 

 

Flow rate 0.1 – 50 ml/min
Maximum operating pressure 30 MPa (4351 PSI)
Repeatability of flow rate adjusting ± 1 %
Accuracy of flow rate setting ± 2 %
Wetted materials stainless steel, PEEK, ceramic, seals
Communication RS232
Power supply 24 – 36 V DC
Power input 100 W
Dimensions W x H x D 212 x 153 x 338 mm
Weight 7 kg
Output capillary outer diameter 1/16”