THETA100 Preparative Pump

100ml/min 15MPa
OEM built in pump with flow rate up to 100ml/min.
Availability

Related variants

Manufacturer
Ecom
Part number
PTC0000X
Theta 100 is unit with two pump pistons connected in parallel. Flow-rates range is from 1 to 100 ml/min. and maximum operating pressure of  15 MPa (2176 PSI). 
 
It is suited for preparative and flash applications in liquid chromatography but also for solvent pressurizing by samples extractions, etc. Beneficiary is also a very stable run even at low flow rates.
 
This pump is designed as OEM / built-in unit.
 
There is a possibility to use this pumps even at high pressure gradient mode, where are two, three or four units controlled from PC using RS232 or voltage.
 
Control board is mounted at the unit back side therefore the installation is very easy. Only connect power voltage and RS232 and pump is ready to work.
 
When working with buffered solvents, it is possible to use pistons back washing.
 
Pumps are supported with software ECOMAC and Clarity.
 
THETA PUMP isn't equipped with pressure sensor.
 
 
 
Flow rate 1 – 100 ml/min
Maximum operating pressure 15 MPa (2176 PSI)
Repeatability of flow-rate (1ml/min. 12MPa H2O) ±1 %
Flow rate setting 0,1 ml/min steps
Repeatability of flow rate adjusting ±1 %
Accuracy of flow rate setting ±2 %
Wetted materials stainless steel, PEEK, ceramic, seals
Communication RS232
Control RS232
Power supply 24 – 36 V DC
Power input 100 W
Dimensions W x H x D 212 x 153 x 338 mm
Weight 7 kg
Output capillary outer diameter 1/16”
Input tubing outer diameter 1/8”
Filename Type
Info-Theta50_100_300_pump-en.pdf pdf (171,47 KB)